Enter the characters you see below Sorry, we just need to make sure you’re not a robot. You have no items in your shopping cart. Using a Plunge Router in a Router Table? Are black & decker router manual plunge router and a router table a good match?
Could I get some expert advice? I’ve done it for years, with various brands of routers. The main difficulty is the awkwardness of adjusting the height of the bit above the table. Some people argue that a plunge router isn’t a good choice for a router table because it has too much play in the mechanisms for the most accurate work. Modern plunge routers are very sturdily built, and you won’t notice any degrade in performance. The best reason to use a plunge router in a table is because you can only afford one router and a big plunge router is it. You can keep the fixed base installed in your router table all the time, so it’s always a quick operation to convert from handheld to table use.
If the router will stay mounted in the table, and not be removed for plunge work, consider removing the springs from the plunge mechanism. They are there to counteract gravity when the router is right-side-up, but will work against you when it is upside-down, as it will be in the table. Lee Grindinger: “Go ahead and mount it in your table. Make sure your depths are well locked when you set the thing up. Not everyone can afford a dedicated router for a table, so it’s common to use the same router for both handheld operations and table work.
As always, just be very cautious as you use it. Using a plunge router in a router table is a fairly common practice, and if you already own one, you’ll be glad to know that predrilled router table plates are available for a variety of models and manufacturers. And there’s a large plate option too, for huskier routers like the Porter Cable 7539. I’m hoping that I’m not doing something dangerous, but a friend told me to remove the springs from my Ryobi plunge router when mounting it on the table.
It seems to work fine, the adjustments are easy to make, and there’s no visible chatter marks on completed pieces. Is it okay to remove the springs without some kind of hidden danger? That said, we’re pretty sure that the sole purpose of the springs is to lift the router motor when you are using it as a handheld tool. The springs are, of course, counter productive when the router is upside-down in a table. Depth adjustment and locking on the power switch can be a little tricky upside down until you get used to it. 4 pre-drilled aluminum plate available here at Rockler. When I adjust the depth, I just position my fence over the top of my plate.